Lectrosonics H175DC User Manual

Browse online or download User Manual for Accessories communication Lectrosonics H175DC. Lectrosonics H175DC User Manual

  • Download
  • Add to my manuals
  • Print
  • Page
    / 12
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
H175DC
Plug-On Transmitter
OPERATING INSTRUCTIONS
and trouble-shooting guide
Digital Code Squelch
LECTROSONICS, INC.
Rio Rancho, NM
Page view 0
1 2 3 4 5 6 ... 11 12

Summary of Contents

Page 1 - H175DC

H175DC Plug-On Transmitter OPERATING INSTRUCTIONS and trouble-shooting guide Digital Code Squelch LECTROSONICS, INC. Rio Rancho, NM

Page 2

SPECIFICATIONS AND FEATURES Operating frequencies: 169 to 172 MHz; 174 to 186 MHz RF Power output: 50mW Deviation: ±15kHz Spurious radiation: 55d

Page 3 - INTRODUCTION

Plug-On Transmitter SERVICE AND REPAIR If your system malfunctions, you should attempt to correct or isolate the trouble before concluding that the

Page 4 - GENERAL DESCRIPTION

LIMITED ONE YEAR WARRANTYThe equipment is warranted for one year from date of purchase against defects in materials or workmanship provided it was pur

Page 5 - CONTROLS AND FUNCTIONS

This page intentionally blank. 2

Page 6 - Locking tab fully retracted

Plug-On Transmitter INTRODUCTION Thank you for selecting the Lectrosonics Professional Series wireless microphone system. This system represents well

Page 7 - Plug-On Transmitter

GENERAL DESCRIPTION The H175DC is a “plug-on” transmitter that converts any microphone with an XLR connector to wireless operation. The transmitter i

Page 8 - POLARITY

Plug-On Transmitter CONTROLS AND FUNCTIONS The H175DC may be used with a wide variety of microphones. The 3-pin XLR type connector on the H175DC all

Page 9 - TROUBLESHOOTING

OPERATING INSTRUCTIONS 1) Install the Microphone onto the transmitter. a. Unscrew the collar by turning it fully clockwise until it stops. Lock

Page 10 - SPECIFICATIONS AND FEATURES

Plug-On Transmitter 2) Turn on the receiver and adjust the output level to minimum. 3) Turn on the transmitter. The CODE LED on the receiver

Page 11 - RETURNING UNITS FOR REPAIR

BATTERY REPLACEMENT The H175DC transmitter is powered by a standard alkaline 9 Volt battery. It is important that you use ONLY an ALKA-LINE battery

Page 12 - LIMITED ONE YEAR WARRANTY

Plug-On Transmitter TROUBLESHOOTING Before going through the following chart, be sure that you have a good battery in the transmitter. It is importan

Comments to this Manuals

No comments