M170 Belt Pack Transmitter OPERATING INSTRUCTIONS and trouble-shooting guide LECTROSONICS, INC. Rio Rancho, NM
SERVICE AND REPAIR If your system malfunctions, you should attempt to correct or isolate the trouble before concluding that the equipment needs repai
M170-BGO SUPPLEMENTAL SHEET The M170-BGO was designed specifically for bingo halls. This transmitter is a lower cost alternative to a traditional s
SPECIFICATIONS AND FEATURES Operating frequencies: 150 to 216 MHz RF Power Output: 50 mW Deviation: ±15kHz Spurious Radiation: 60dB below carrier
LIMITED ONE YEAR WARRANTY The equipment is warranted for one year from date of purchase against defects in materials or workmanship provided it was pu
INTRODUCTION Thank you for selecting the M170 Series transmitter. The M170 Series transmitters operate on high band frequencies from 150 MHz to 216
GENERAL DESCRIPTION The M170 Series transmitter is offered in five versions. The standard model is the M170. The M170-LS, M170-XLR, M170-BGO, and t
M170 VARIATIONS 3
CONTROLS AND FUNCTIONS The MIC JACK is a locking micro jack that supplies "phantom power" for electret microphones such as the Lectrosonics
CONTROLS AND FUNCTIONS (cont’d.) The XLR MIC JACK (M170-XLR only) is a standard 3-pin audio connector (Switchcraft A3F) that will accept standard han
BATTERY INSTRUCTIONS The battery you use in the M170 Series transmitter should be a 9 Volt alkaline, available almost everywhere. An alkaline batter
OPERATING INSTRUCTIONS (cont’d.) 6) A small screwdriver is supplied with the transmitter. The screwdriver is used to adjust the audio gain of the tr
TROUBLESHOOTING Before going through the following chart, be sure that you have a good battery in the transmitter. It is important that you follow t
Comments to this Manuals