1Frequency Agile UHF Miniature Belt-Pack TransmitterRio Rancho, NM – USAMM400AMM400AMM400AMM400AMM400A DIGITAL HYBRID WIRELESSTM MINIATURE UHF BELT-
MM400A with the number of blinks listed in Step 1. The mode setting will remain the same until you reset it with the procedure listed above. ADJ
Frequency Agile UHF Miniature Belt-Pack Transmitter OPERATING NOTES The AUDIO LEVEL control should not be used to control the volume of your so
MM400A TROUBLESHOOTING Before going through the following chart, be sure that you have a good battery in the transmitter. It is important that you f
Frequency Agile UHF Miniature Belt-Pack Transmitter SPECIFICATIONS AND FEATURES Operating frequencies: Block 21 537.600 - 563.100 Block 22 563
MM400A SERVICE AND REPAIR If your system malfunctions, you should attempt to correct or isolate the trouble before concluding that the e
LIMITED ONE YEAR WARRANTY The equipment is warranted for one year from date of purchase against defects in materials or workmanship provided it was pu
MM400A The MM400 transmitter is FCC type accepted under Part 74: 536-608 MHz and 614-806 MHz LECTROSONICS, INC. 2
Frequency Agile UHF Miniature Belt-Pack Transmitter Thank you for selecting the Lectrosonics MM400A miniature transmitter. The unique design pr
MM400A GENERAL TECHNICAL DESCRIPTION GENERAL The 400 system uses 75 kHz wide deviation for an extremely high signal to noise ratio. The
Frequency Agile UHF Miniature Belt-Pack Transmitter NO PRE-EMPHASIS/DE-EMPHASIS The signal to noise ratio of the 400 system
MM400A CONTROLS AND FUNCTIONS –10 –20 POWER MIC JACK POWER LED FREQUENCY SELECT SWITCH COVER PLATE MODULATION LEDs AUDIO LEVEL ANTENNA BATTERY C
Frequency Agile UHF Miniature Belt-Pack Transmitter kit. (See WPMC-3 and WPMC-10 in Accessories Catalog.) A Switchcraft 850 conn
MM400A BATTERY INSTALLATION WARNING! TO PREVENT INTERNAL CORROSION! If the transmitter is wet (either due to immersion or high levels
Frequency Agile UHF Miniature Belt-Pack Transmitter OPERATING INSTRUCTIONS WARNING! TO PREVENT INTERNAL CORROSION! If the transmitter
Comments to this Manuals