Lectrosonics UM200c User Manual

Browse online or download User Manual for Accessories communication Lectrosonics UM200c. Lectrosonics UM200c User Manual

  • Download
  • Add to my manuals
  • Print

Summary of Contents

Page 1 - UM200C

UM200C FREQUENCY-AGILE UHF BELT-PACK TRANSMITTER OPERATING INSTRUCTIONS LECTROSONICS, INC. Rio Rancho, NM www.lectrosonics.com

Page 2 - TABLE OF CONTENTS

UM200C MICROPHONE CORD TERMINATION 1 2 3 45 VIEW FROM SOLDER SIDE OF PINS 0.3" 0.15" Heatshrink Tubing TA5F Connector Assembly Mic Cord S

Page 3 - INTRODUCTION

Frequency Agile UHF Belt-Pack Transmitter 5-PIN INPUT JACK WIRING The wiring diagrams shown on the next page represent the basic wiring nece

Page 4 - DUAL BAND COMPANDOR

UM200C RF BYPASSING 2 WIRE MIC 3 WIRE MIC Some mics require RF protection to keep the radio signal from affecting the capsule, even though the t

Page 5 - Rio Rancho, NM – USA

Frequency Agile UHF Belt-Pack Transmitter TROUBLESHOOTING Before going through the following chart, be sure that you have a good battery in the trans

Page 6 - CONTROLS AND FUNCTIONS

UM200C SPECIFICATIONS AND FEATURES Operating frequencies: 537.600 to 607.900 MHz 614.100 to 767.900 MHz Frequency selection: 256 frequencies in 100

Page 7 - THE BELT CLIP

Frequency Agile UHF Belt-Pack Transmitter SERVICE AND REPAIR If your system malfunctions, you should attempt to correct or isolate the

Page 8 - Press outward on the

LIMITED ONE YEAR WARRANTY The equipment is warranted for one year from date of purchase against defects in materials or workmanship provided it was pu

Page 9 - OPERATING NOTES

UM200C TABLE OF CONTENTS INTRODUCTION ... 3 GENERAL T

Page 10 - MICROPHONE CORD TERMINATION

Frequency Agile UHF Belt-Pack Transmitter INTRODUCTION Thank you for selecting the Lectrosonics UM200C frequency agile, belt-pack trans-mit

Page 11 - 5-PIN INPUT JACK WIRING

UM200C GENERAL TECHNICAL DESCRIPTION The UM200C transmitters are comprised of a number of functional sub-systems as shown in the block dia

Page 12 - LINE LEVEL SIGNALS

Frequency Agile UHF Belt-Pack Transmitter NO PRE-EMPHASIS/DE-EMPHASIS The signal to noise ratio of the 200 system is high enough

Page 13 - TROUBLESHOOTING

UM200C CONTROLS AND FUNCTIONS ANTENNA OFF ON –20 0 LECTROSONICS LEVEL AUDIO UM200C ADJUST FREQUENCY 1.6M 100K 01 2 3 4 5 6 789A B C D E F

Page 14 - SPECIFICATIONS AND FEATURES

Frequency Agile UHF Belt-Pack Transmitter Since the internal circuits are all tightly regulated and the RF output stage has a separate dis

Page 15 - SERVICE AND REPAIR

UM200C BATTERY INSTALLATION The transmitter is powered by a standard alkaline or lithium 9 Volt battery. It is important that you use ONLY an AL

Page 16 - LIMITED ONE YEAR WARRANTY

Frequency Agile UHF Belt-Pack Transmitter 7) While speaking or singing at the same voice level that will actually be use

Comments to this Manuals

No comments