Lectrosonics Long Ranger II User Manual download pdf (Page 10)

ADDING A SECOND WIRELESS CHANNEL TO YOUR LONG RANGER II

A very popular feature of the LONG RANGER II is the ability to add a second wireless channel to an

existing system in the field. The Lectrosonics 170 MINI-LR system was expressly designed for that

purpose. The standard system consists of a SR170-LR receiver, an M170 transmitter and a

microphone. Options include the M170-XLR transmitter and a number of other microphones.

The SR170-LR receiver is supplied with velcro attaching strips and is equipped with the necessary

cabling for making the connections to the LONG RANGER II. The receiver is installed on the LONG

RANGER II by performing the following steps as shown in the diagram:

1) The antenna cable for the SR170-LR is packed in a zip-lock plastic bag together with screws,

lock washers and the velcro strips. The antenna cable is terminated with two ring lugs. Feed

the lug end of this cable through the hole in the LONG RANGER II rear panel upright. Dress

the cable along the top of the battery pack along with the speaker wires as shown in the figure

below.

2) Remove and discard the two black Phillips head screws from the bottom of the antenna strip on

the right-hand side of the speaker and from the speaker mounting block. Using the supplied

bright screws and lockwashers, connect the shield ring lug (identified by the hump in the

insulation) to the speaker mounting block. Connect the center conductor ring lug to the

antenna. Tighten both screws securely.

ANTENNA

BLACK

LEAD

WHITE

LEAD

BLACK

LEAD

SPEAKER

MOUNTING

BLOCK

Figure 6 - SR170-LR Antenna Connections

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16 17 18

No comments

Lectrosonics Long Ranger II User Manual Page 10