DC1 AUTOMATIC PRE-PROCESSOR WITH ADAPTIVE PROPORTIONAL GAIN ALGORITHM* (Version 2.0 and higher) OPERATING INSTRUCTIONS LECTROSONICS, INC. Rio Ranch
7) Set the Level Match for each channel. Press the UP button to advance to the Level Match screen then press SELECT repeatedly to move the cursor t
AUTOSET DESCRIPTION The AUTOSET function of the DC1 is included to automatically optimize the performance of the DC1. AUTOSET allows any m
AUTOSET PROCEDURE STEP BY STEP INSTRUCTIONS 1) If the DC1 is used with a sound system, turn the sound system on and set it for a normal listening le
DC1 Function Summary and Default Settings Feature/Function Range Factory Default Mem 1 Factory Default Mem 2 User Mem 3 Input Type HIGH/LOW Channel 1
SPECIFICATIONS Mic Input: Impedance: 8.1k Ohms balanced Type: Electronically balanced and RF filtered Gain: Unity EIN, 20-20kHz -127dBu at High G
SERVICE AND REPAIR If your system malfunctions, you should attempt to correct or isolate the trouble before concluding that the equipment needs repair
LIMITED ONE YEAR WARRANTY The equipment is warranted for one year from date of purchase against defects in materials or workmanship provided it was p
INTRODUCTION The DC1 is a sophisticated, microprocessor-based audio signal processor which will add the capability of automatic mixing to any standar
THEORY OF OPERATION Please refer to the block diagram of the DC1 for the following discussion. The DC1 has two major subsystems; the analog signal pr
THEORY OF OPERATION (cont’d) The DC1 audio signal path is designed to eliminate any signal degradation from the DC1 itself. State of the art microph
INSTALLATION Installation of the DC1 is quite straightforward. To use one DC1 by itself, simply plug the microphone cables from up to four m
FRONT PANEL DESCRIPTION HEADROOM LED METER - Indicates the instantaneous amount of headroom available in the channel. Internal signals are monitored
REAR PANEL DESCRIPTION MICROPHONE INPUT - Accepts a balanced microphone signal. Fully balanced differential in
OPERATING INSTRUCTIONS Before describing the setup procedure for the system, each function available in the DC1 will be explained. AUTO SKEW DISPLAY
SETUP PROCEDURE 1) Initialize the memory settings to factory defaults (optional.) If you do NOT want to lose any previously saved settings, proceed
Comments to this Manuals