Lectrosonics SPNDNT User Manual

SPNDNTNetwork ProcessorINSTALLATION AND STARTUP GUIDERio Rancho, NM, USAwww.lectrosonics.comFill in for your records: Serial Number: Purchase Date:A

ASPEN Digital ProcessorLECTROSONICS, INC.10Dante SoftwareDante ControllerThis is a second software package needed to route network audio signals betwe

Installation and Quick Start GuideRio Rancho, NM11Mandatory SettingsSet up the system in the Switched Mode in the Net-work Config screen in Dante Contr

ASPEN Digital ProcessorLECTROSONICS, INC.12Cabling Of Stacked UnitsNOTE: The SPNDNT must always be the Master at the top of the stack to synchronize

Installation and Quick Start GuideRio Rancho, NM13ASPEN RS-232 Port123456789123456789DCDRXTXDTRGNDDSRRTSCTSRITXRXGNDHost Serial Port (PC)ASPEN RS-232

ASPEN Digital ProcessorLECTROSONICS, INC.14 100-240V50/60Hz 30WASPEN PORTSETHERNETRS-232SPN 1624OUTPUTSINPUTSOUTPUTSINPUTSGND+5VPROG INPROG OUTGNDPRO

Installation and Quick Start GuideRio Rancho, NM15 100-240V50/60Hz 30WASPEN PORTSETHERNETRS-232SPN 1624OUTPUTSINPUTSOUTPUTSINPUTSGND+5VPROG INPROG OU

ASPEN Digital ProcessorLECTROSONICS, INC.16System Setup ExamplesBasic ConfigurationX = INPUTO = OUTPUTThis example illustrates the basic signal routing

Installation and Quick Start GuideRio Rancho, NM17Set up the inputs for the microphones with the gain value set to achieve 0 dBu on the meter during s

ASPEN Digital ProcessorLECTROSONICS, INC.18 Using the AEC on Network ConnectionsWhen the Trio or Conference processor is used in the ASPEN subsystem,

Installation and Quick Start GuideRio Rancho, NM19Assign the two microphone inputs to Mix Buses 16 and 17 to be used for local sound reinforcement. Ma

ASPEN Digital ProcessorLECTROSONICS, INC.2

ASPEN Digital ProcessorLECTROSONICS, INC.20Assign the Dante receive channel 1 to Mixes 16 and 17 to deliver the audio from the network into the local

Installation and Quick Start GuideRio Rancho, NM21

ASPEN Digital ProcessorLECTROSONICS, INC.22Multiple Site Conferencing This example illustrates how multiple ASPEN subsys-tems can be set up identicall

Installation and Quick Start GuideRio Rancho, NM23Set up the inputs for the microphones connected to the SPNTrio. Adjust the gain so the level is clos

ASPEN Digital ProcessorLECTROSONICS, INC.24In this example, the processors in the subsystems all subscribe to receive audio from the other two subsys-

Installation and Quick Start GuideRio Rancho, NM25

ASPEN Digital ProcessorLECTROSONICS, INC.26FCC Part 15 ComplianceThis device complies with Part 15 of the FCC Rules. Operation is subject to the follo

Installation and Quick Start GuideRio Rancho, NM27Service and RepairIf your system malfunctions, you should attempt to correct or isolate the trouble

13 March 2013581 Laser Road NE • Rio Rancho, NM 87124 USA • www.lectrosonics.com(505) 892-4501 • (800) 821-1121 • fax (505) 892-6243 • sa

Installation and Quick Start GuideRio Rancho, NM3This symbol, wherever it appears, alerts you to the presence of uninsulated danger-ous voltage inside

ASPEN Digital ProcessorLECTROSONICS, INC.4IMPORTANT NOTICE:Several settings are mandatory to ensure the processor will connect and operate properly wi

Installation and Quick Start GuideRio Rancho, NM5OverviewWhat is Dante?Audinate’s patent pending Dante™ technology is a flexible Internet Protocol (IP)

ASPEN Digital ProcessorLECTROSONICS, INC.6Front PanelHeadphone MonitorStandard 1/4 inch jack and level control. Drives both channels of stereo headpho

Installation and Quick Start GuideRio Rancho, NM7USB Driver InstallationThe ASPEN USB drivers are installed from the ASPEN Installation Disk, which co

ASPEN Digital ProcessorLECTROSONICS, INC.8ASPEN SoftwareASPEN Control PanelASPEN processors are set up and monitored using the ASPEN Control Panel pro

Installation and Quick Start GuideRio Rancho, NM9The End User License Agreement screen appears. Click on I Agree, then on Next to continue.It is usual