Lectrosonics SPNDNT User Manual download pdf (Page 11)

Installation and Quick Start Guide

Rio Rancho, NM

Mandatory Settings

Set up the system in the Switched Mode in the Net-

work Conﬁg screen in Dante Controller. Once every-

thing is set up and audio is ﬂowing to and from the

network, a second network and gigabit switch can be

added and the mode can be changed to Redundant.

Connect an SPNDNT Dante port to the computer either

directly or through a gigabit switch.

Dante Primary Port

Connect the PC to the Primary Port in case the mode

had previously been set to Redundant. Conﬁrm that

the 1G and LINK/ACT LEDs next to the Dante port are

ﬂickering.

Launch the Dante Controller software. A brief splash

screen appears, followed by the Network View/Routing

screen. The serial number of the connected processor

will appear in the bars labeled Receivers and Trans-

mitters.

Processor name and

serial number appear in

the blue bars

Double click on either blue

bar to open the Device View

dialogue box

Double click on the processor name/serial number to

open the Device View dialog box. Under the Network

Conﬁg tab, select Switched.

Select

Network

Conﬁg

Select

Switched

Select the Device Conﬁg tab, then set the sample

rate to 48k. The sample rate MUST be 48k so the DSP

(ﬁlters, etc.) will operate as they should.

Device Conﬁg Tab

Select 48k Sample Rate

Latency under the same tab can be adjusted depend-

ing upon the number of switches in the network.

The other tabs in the Device View dialog box are used

to rename channels and check the status of several

parameters.

Consult the Help menu for details and explanations of

Dante Controller software.

Made In the USA

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 27 28

Comments to this Manuals

No comments

Lectrosonics SPNDNT User Manual Page 11

Comments to this Manuals

Related products and manuals for Audio accessories Lectrosonics SPNDNT