Lectrosonics SPNTWB User Manual Page 21

  • Download
  • Add to my manuals
  • Print
  • Page
    / 24
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 20
Installation and Startup Guide
Rio Rancho, NM
21
Network Setup
The SPNTWB is IP addressable over an ordinary Ether-
net network. The use of DHCP to configure the network
interface is recommended for easy setup.
Using the front panel LCD, navigate to SYS>Network
Settings and set Use DHCP to YES.
Connect the processor into the network and cycle the
power. The processor will boot up and the DHCP server
will assign an IP address. The address can be viewed in
the Network Settings display.
IP address will
appear here.
NOTE: Changes to the network settings do not
take effect until the processor power is cycled off
and back on again.
Web Browser Interface
A simple interface is provided to communicate directly
with the processor through a network using the HTTP
port and a standard browser. This interface provides
access to the processor in the same manner as the
Command Terminal interface in the software.
Launch your browser and enter the IP addresses as-
signed to the processor in the top window.
When the processor is connected a summary screen
will appear to verify the connection. Click on the link to
enter the dialogue screen.
Click on the link to enter
the dialogue screen
Enter ASPEN commands and view the replies to verify
the processor setup or to make adjustments.
Enter Commands here
View Replies here
Page view 20
1 2 ... 16 17 18 19 20 21 22 23 24

Comments to this Manuals

No comments