UR190 UHF COMPACT RECEIVER OPERATING INSTRUCTIONS and trouble-shooting guide LECTROSONICS, INC. Rio Rancho, NM
TROUBLESHOOTING Before going through the following chart, be sure that you have a properly connected AC adapter. The POWER LED should glow brightly. S
SERVICE AND REPAIR If your system malfunctions, you should attempt to correct or isolate the trouble before concluding that the equipment needs repai
SPECIFICATIONS AND FEATURES Operating Frequencies: 470MHz to 608MHz, crystal controlled Sensitivity: Better than 0.35 uV for 20dB SINAD; 1.5 uV for
LIMITED ONE YEAR WARRANTY The equipment is warranted for one year from date of purchase against defects in materials or workmanship provided it was pu
INTRODUCTION Thank you for selecting the Lectrosonics Professional Series wireless microphone system. This system represents well over 10 years of
GENERAL TECHNICAL DESCRIPTION AFC 2nd Mixer Demodulator RF LED Squelch 0dB LED -20 LED On Off Power LED +9V Helical Resonator Filter GAsFET Preamp He
The Dual Band Compandor is driven by a multiple pole active low-pass filter. The filter ensures that supersonic noise will not cause the compandor to
CONTROLS AND FUNCTIONS RECEIVER FRONT PANEL MODULATION LEDs Indicate the modulation (audio level) of the incoming signal, and can be used for proper
- --RF LED Lights when the transmitter is turned on and the receiver has a good signal. When the carrier signal from the transmitter is too weak to p
RECEIVER REAR PANEL 12 VDC INPUT Connects to the supplied CH-12 AC adapter for powering the receiver from a 110/120V AC source. The receiver may also
T SIGNALNDIRECT SIGNALDIRECT SIGNALRECEIVERANTENNA USE AND PLACEMENT Connect the antenna to the front panel jack. Position the antenna so that it is
OPERATING INSTRUCTIONS 1) Connect the power cord. 2) Attach and extend the antenna. 3) Connect the audio cable. 4) Set the front panel switch
Comments to this Manuals