• Worn over the head or around the neck
• Omni-directional element & adjustable mic
boom for maximum gain and minimum wind
• Adjustable headband cushions
• Built in volume control
• Rugged construction for long life
The HM142V headset microphones are a lightweight
design for use with a wide variety of Lectrosonics wire-
less PA, microphone and IFB systems. The stainless steel
headband and boom are adjustable for maximum comfort
The foam temple pads are attached to machined alumi-
num assemblies clamped to the headband. The position
of the temple pad opposite the mic boom is adjustable for
a comfortable, secure ﬁt. The stainless steel headbands
are simply shaped by hand to ﬁt the head.
The pickup capsule is an omnidirectional electret type,
powered by a DC bias present on the input jack of Lec-
trosonics transmitters. The omni-directional capsule
provides a wide, ﬂat frequency response, plus ultra low
wind noise and clothing “rattle.”
The stainless steel microphone boom is mounted in a ball
joint to allow adjustment to position the microphone to the
left and slightly away from the mouth.
The volume control on the temple pad is used to temporar-
ily control feedback when used with a sound system.
Available with a locking micro plug, TA5F 5-pin plug, or
standard 3.5mm mini plug for use with Lectrosonics wire-
Rugged machined aluminum and stainless steel are used
to construct the headset for years of heavy use.
Rio Rancho, NM, USA