CONTROLS AND FUNCTIONS
MAXI MOUSE PORTABLE SPEAKER/AMP
INPUTS AND VOLUME CONTROL
INPUTS "A" and "B" are standard 1/4" phone jacks which may be used with either an instrument or a
high impedance microphone. These are switching jacks that turn on the amplifier when you plug in
your instrument cord. The input impedance is 10 megohms to match any type of instrument pickup.
When used with low impedance microphones, a matching transformer should be used to convert the
microphone output to high impedance. A suitable matching transformer is readily available at music
stores or electronics dealers in your area.
Each input on the Maxi Mouse has a separate VOLUME and TONE control for individual adjustment of
each channel. The MASTER VOLUME control adjusts the total output of the amplifier
EQUALIZATION SWITCH
This three position switch changes the frequency response of the inputs. In the left-most position, both
inputs A and B have a frequency response with reduced mid-range and boosted bass and treble. The
"INST"" equalization generally sounds better for almost any type of instrument when there are no other
signal processors (effects boxes) in use. The center position sets input A to a flat response and input
B to the "INST" equalized response. The right-most position sets both inputs to a flat response.
MASTER VOLUME
For a flat, clean type of sound or when used with microphones, set the MASTER VOLUME control to
"VOICE RANGE" or fully clock-wise, and adjust the loudness of each input with the volume control next
to each input jack.
A distorted (over-driven) sound is produced by setting the MASTER VOLUME counter-clockwise to a
lower position and turning the input volume up to near maximum. When either input is set for a
distorted, over-driven sound, the sound from both inputs will be distorted.
SPEAKER OUTPUT
This output jack accepts a standard 1/4" phone plug. When the plug is inserted fully, the output will
drivea2to4Ohm speaker. The jack is also equipped with a detent that allows the plug to be inserted
half-depth, providing a "line" output for connecting into another amplifier or tape recorder with an input
impedance of about 10K Ohms.
CH40 INPUT JACK
To charge the Maxi Mouse, insert the charger plug fully into the CH-40 INPUT jack on the control
panel, and plug the CH-40 charger into a 110 Volt wall outlet. The green LED above the CH-40 INPUT
jack will light up when the unit is taking a charge. Leave the charger connected in this manner until the
green LED goes out, indicating that the batteries are fully charged. You may leave the charger plugged
in after the green light has gone out with no danger of damage to the system. In fact, we recommend
charging the system whenever it is not in use, then the system will always be "ready to go". A fully
discharged battery pack will take about 12 hours to recharge.
5
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals