Lectrosonics FM875 User Manual download pdf (Page 4)

– –

CONTROLS AND FUNCTIONS

MODULATION

–20

LIMIT

WIRELESS MIC

VOLUME

OUT

POWER

CHARGE

MIC LEVEL

OUTPUT

LECTROSONICS

LO-Z

BAL

IN/OUT

OMNI–BUS

CHARGE UNTIL GREEN LED

GOES OUT OR LONGER

ADJUST MIC GAIN ON TRANSMITTER

UNTIL LIMIT LED FLASHES ON VOICE PEAKS

AUX

VOLUME

AUX

MIC OR AUX

LINE

(Items are listed in right to left order as shown on the panel above.)

POWER: A toggle switch which turns the power off and on.

CHARGE: Jack for CH-40 charger.

POWER LED: A red LED indicates when the FM875 is turned on and the batteries are charged

up enough to operate the system. This LED will also light up when the batteries

are being recharged if the CH-40 charger is properly connected. This led will go

out when the batteries are discharged.

CHARGE LED: Lights when the unit is being charged. This green led will go out when the

batteries are fully charged.

OMNI-BUS IN/OUT: An RCA phono jack that functions both as a line level input and line level output.

This "omnibus" jack is primarily used for interconnecting several FM875s together

for simultaneous operation. This jack can also be used with a tape deck to either

record from or play back into the FM875. When used with a tape deck or other

audio source, the sound output level must be controlled by the volume control on

the tape deck since there is no volume control on the FM875 for this jack.

IN/OUT

OMNI BUS

Connect two FM875s

together using the

OMNI-BUS jacks.

OMNI BUS

IN/OUT

Male

RCA

Male

RCA

FM 875 #1 FM 875 #2

When connected in this manner, the volume control knob on one unit will affect

the loudness of that source (wireless, aux, etc.) on both FM875 systems.

1 2 3 4 5 6 7 8 9 ... 17 18

Comments to this Manuals

No comments

Lectrosonics FM875 User Manual Page 4

Comments to this Manuals

Related products and manuals for Acoustics Lectrosonics FM875