Lectrosonics Long Ranger II User Manual Page 8

  • Download
  • Add to my manuals
  • Print
  • Page
    / 18
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 7
INITIAL EQUIPMENT ADJUSTMENTS
This section covers the initial adjustments to the transmitter and LONG RANGER II that must be made
before the system is placed into operation. The step-by-step procedures are listed in the order in which
they should be performed:
1) Turn LONG RANGER II power on - The POWER lamp lights.
2) Rotate both volume controls counter-clockwise to their minimum settings.
3) Position yourself behind the LONG RANGER II so that the sound from the speaker will be
directed away from the microphone.
4) Plug your microphone into the transmitter. Rotate the plug clockwise to make sure the
connection is locked.
5) Turn the transmitter power on and verify that the red lamp on it lights. If the lamp is very dim
or does not light, replace the battery.
6) Observe that the green RF lamp on the LONG RANGER II control panel is lighted. This
verifies that the unit is receiving a useable signal from the transmitter.
7) Position the microphone on your person in the location it will be during actual operation. The
microphone should be within 3 inches of the mouth to minimize the possibility of "feedback". If
the headset mic is being used, position the mic element at the corner of the mouth and rotate
the white volume control knob fully clockwise.
8) A small screwdriver is supplied with the transmitter. The screwdriver is used to adjust the
audio gain of the transmitter to match your microphone and your voice. The adjustment is
made while observing the MOD LEVEL lamps on the LONG RANGER II control panel:
a)
b)
Speak at the voice level you will be using during actual operation.
While speaking, adjust the transmitter gain until the green MOD LEVEL lamp is lighted or
flickers and the red MOD LEVEL lamp blinks only on the loudest words. Raise and lower
your voice while observing the lamps. The red lamp should only blink occasionally.
AS YOU OBSERVE THE LEDs
WHILE SPEAKING
ADJUST THE TRANSMITTER
ON THE RECEIVER
GREEN LED
RED LED
OFF
RF
12V DC
OUTPUT
CHA
LAMP
CH-40
CHARGE
POWER
AUX IN/OUT
WIRELESS
MICROPHONE
VOLUME
MOD
LEVEL
Figure 5 - Transmitter Gain Adjustment
7
Page view 7
1 2 3 4 5 6 7 8 9 10 11 12 13 ... 17 18

Comments to this Manuals

No comments