Lectrosonics WM - Manual User Manual download pdf (Page 12)

LECTROSONICS, INC.

Optional RM Remote Control

The RM unit gives you remote control of SM Series

transmitters using an audible tone delivered to the mi-

crophone. The panel layout is the same as the transmit-

ters. Simply set the desired value or mode on the LCD,

then press the send button to set the transmitter to the

same setting or mode.

Hold the speaker on the RM close to the microphone

when pressing the pushbutton. A “dweedle” tone will

play from the RM speaker into the microphone and the

parameter on the transmitter will be set immediately.

Available adjustments:

• Audioinputgain

• Frequency

• LockorUnlockModes

• SleepModeON/OFF

Send Button

Speaker

When the transmitter is in the power saving sleep

mode, it uses only 20% of the normal battery drain, so

battery life will be approximately 4 times longer. This

is especially useful in situations where the transmitter

is buried deep inside costuming and there are wait-

ing periods between use. The transmitter can “sleep”

for several hours and then be awakened and adjusted

when the production is about to begin.

Several “Dweedle tones” can also be downloaded from

the web site at:

http://www.lectrosonics.com/Transmitters/rm.html

The dweedle tones can be played back through an MP3

player, SmartPhone, etc., and in most cases, will even

work with walkie talkies. The tones will not work through

the loudspeakers of a sound system because the reﬂec-

tions and reverberation in the room will alter the tones.

Powering the RM on and off

To turn the RM on or off, press the AUDIO and FREQ

buttons together brieﬂy. The unit powers up on the page

that was displayed when the unit was powered off last.

The setup screens are accessed with the AUDIO and

FREQ buttons. Once on the desired screen, the value is

adjusted with the UP and DOWN arrow buttons.

To change a transmitter’s setting via the RM, select

the screen and value, then press the SEND button

while holding the speaker close to the microphone.

The speaker should be uncovered and held within a

few inches of the transmitter’s microphone. The longest

usable range is about 6 feet, depending on the micro-

phone and volume settings used.

Only the speciﬁc function displayed is altered. For ex-

ample, if the remote control is on the Aud (audio level/

gain) screen, pressing the send button will set the gain

on the transmitter but will not affect any other setting.

Setup Screens

The AUDIO button cycles through 4 screens:

1) Aud - set transmitter’s audio level

2) SLEEP/unSLP - cause transmitter to sleep or wake up

3) Loc/unLoc - lock or unlock transmitter’s buttons

4) Loud - adjust RM speaker volume

(press SEND button for a sample tone)

5) Pr - Transmit outpit power (only in SM & SMVs)

The FREQ button cycles through 2 or 3 screens, de-

pending on the settings:

1) CH - set transmitter’s channel

(using block-independent hex code)

2) b - select a block number

(optional — uncovers next page)

3) 000.000 - set transmitter’s frequency in MHz

(avail. if a block is selected)

A single AA Lithium battery will operate

the RM for up to several years. Unscrew

the knurled knob for access to the battery

compartment.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 23 24

Comments to this Manuals

No comments

Lectrosonics WM - Manual User Manual Page 12

Comments to this Manuals

Related products and manuals for Accessories communication Lectrosonics WM - Manual