Lectrosonics WM - Quick Start Guide User Manual download pdf (Page 6)

LECTROSONICS, INC.6

Compatibility Mode

In addition to it’s native Digital Hybrid mode, the transmitter will operate with Lectro-

soncs 100 Series, 200 Series and IFB receivers, as well as several analog receivers

from other manufacturers.

From this screen, use the UP and DOWN arrows to select the desired

mode.

 •CP 100: 100 Series mode

 •CP 200: 200 Series mode

 •CP 3: Mode 3 (contact the factory for details)

 •CP 400:400Seriesmode

 •CP IFB: IFB Series mode

 •CP 6: Mode 6 (contact the factory for details)

Output Power

Extended operating range and increased immunity to dropouts can be

selected at the expense of shorter battery life by setting the output

power to 250 mW. Reduced output power will decrease power consumption and extend

battery life at the expense of operating range and immunity to dropouts. Use the UP and

DOWN arrows to select the desired output power.

NOTE: See the speciﬁcations for typical operating times with different batteries and power

levels.

Bias Voltage (phantom power)

The transmitter features unique Servo Bias input circuitry that automatically adjusts the

current to maintain a selected bias voltage for the microphone. This effectively over-

comes a traditional problem with variations in output levels and power supply currents

of different microphones.

Hold the UP arrow button, then press the Audio and Freq buttons together to enter the

setup screen with the RF output turned off.

Press the UP and DOWN arrows to select the desired setting:

•PH 2 Bias at 2 volts for electret mics

 •PH 4 Biasat4voltsforelectretmics

 •PH oFF Bias turned off for dynamic mics

•L InE Bias turned off; live level impedance

Thecorrectbiasvoltagewillbespeciedbythemicrophonemanufacturer.4voltsis

typical for most electret lavaliere microphones. 2 volts is preferred by some mic manu-

facturers such as Countryman for the models B6 and E6.

LCD Backlight Settings

The backlight on the display can be set to stay on all the time or to turn

off after either 30 seconds or 5 minutes of inactivity on the panel

switches. The backlight will turn on and the timer will start over when a

button is pressed. Use the UP and DOWN arrow buttons to select the desired setting.

1 2 3 4 5 6 7 8

No comments

Lectrosonics WM - Quick Start Guide User Manual Page 6