Lectrosonics Long Ranger III User Manual download pdf (Page 10)

INITIAL ADJUSTMENTS TO THE ADD-ON RECEIVER SYSTEM

1) Set up the Long Ranger III system according to the Initial Equipment Adjustments on page 6.

2) Leave the Long Ranger III power turned on. Set both volume controls on the Long Ranger III control panel to

minimum.

3) Turn the Add-On receiver power switch to “ON.” Check to see that the power lamp comes on.

4) Plug the microphone into the transmitter that is on the same frequency as the Add-On receiver. The plug on the

microphone is a twist-lock connector. Make sure there is a good connection. If you are using the headset micro-

phone, turn the white level control knob on the headset fully clockwise (maximum).

5) Install the 9 Volt battery into the transmitter, turn the transmitter on and make sure the red lamp on the transmitter

glows brightly.

6) Check to see that the yellow “RF” lamp on the Add-On receiver glows steadily. This verifies that the receiver is

picking up a good radio signal from the transmitter.

7) This is the most important step in the set up procedure. Place the microphone in the exact position where

you will be using it. Speak at the same voice level that you will use during actual operation. While you speak, use

the supplied screwdriver to adjust the gain control on the transmitter side panel while you observe the MODULA-

TION LEDs on the Add-On receiver front panel. The green LEVEL lamp should flicker or stay lit as you speak.

The red LIMIT lamp should blink only on louder words.

8) Adjust the AUXILIARY INPUT VOLUME control on the Long Ranger III control panel for the necessary loudness.

If the transmitter gain controls have been correctly set on both the Longer Ranger III and the Add-On system, both

volume control knobs on the Longer Ranger III panel will be in about the same position for equal loudness on both

systems. It is not unusual, however, that one of the volume controls may be slightly higher or lower than the other

in normal use.

SPECIAL NOTE TO DUAL CHANNEL USERS

If you are only using one of the two wireless systems, it is best to use the wireless system built into the Long Ranger

III and leave the Add-On receiver turned off. This will prevent unwanted noise, hiss or static that could occur in the

unused receiver from entering the Long Ranger III.

If it is necessary to use the Add-On receiver by itself, turn the WIRELESS MICROPHONE VOLUME control knob on

the Long Ranger III control panel to minimum. Then set the AUXILIARY INPUT VOLUME for the necessary loudness

of the Add-On system.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

No comments

Lectrosonics Long Ranger III User Manual Page 10