Lectrosonics R1 User Manual download pdf (Page 9)

IFB Receiver

SPECIFICATIONS AND FEATURES

Operating frequencies: 537.6 MHz to 608, 614 to 793.5 MHz (in 10 blocks)

Number of frequencies: 256 per block (using 26 MHz wide band)

Channel spacing: 100 kHz

Frequency control: Crystal Controlled Phase Locked Loop

Sensitivity: 1 uv (20 dB SINAD)

Signal/Noise ratio: 95 dB A-weighted

Squelch quieting: 90 dB

AM rejection: 50 dB, 10 uv to 100 mv

Modulation acceptance: ±20 kHz

Spurious rejection: Greater than 70 dB

Third order intercept: 0 dBm

Frequency response: 100 Hz to 10 kHz, (±1db)

Pilot tone: 29.997 kHz, 4.5 kHz deviation (fixed crystal controlled)

Audio output, headphone: 1 Vrms into 50 ohms minimum

Antenna: Headphone cable

Programmable memory: 5 frequencies

Front panel controls: Single knob controls Audio Output Level, Power on, programming

and Scan Frequency Selection

Indicators: 1 red LED Indicator for power on, blinks to indicate channel number, blinks

fast during scan, and has short/long blinking for low battery.

Power requirement: Single 9V Alkaline Battery for approximately 8 hours operation.

Power consumption: 60 ma.

Allen wrench for knob: 0.035” (Lectro part number: 35854)

Weight: 7.3 oz with battery

Size: 3.6 x 2.4 x 0.8 inches (housing only, belt clip and

knob extend beyond the housing.)

Specifications subject to change without notice.

Rio Rancho, NM – USA

1 2 3 4 5 6 7 8 9 10 11 12

No comments

Lectrosonics R1 User Manual Page 9