Lectrosonics UCR110 User Manual download pdf (Page 7)

Compact Receiver

BATTERY INSTRUCTIONS

The battery you use in the receiver should be a 9 Volt alkaline or lithium, available almost everywhere. An alkaline

battery will provide up to 8 hours of operation and a lithium battery will provide up to 20 hours of operation. Carbon zinc

batteries, even if marked “heavy duty” will only provide about 2 hours of operation. Rechargeable batteries will only

operate the receiver for an hour or less. Make sure your batteries are marked

“alkaline” or “lithium.” Short battery

life is almost always caused by weak batteries or batteries of the wrong type.

A steady

“ON” LED corresponds to a fresh battery. The LED will blink to indicate a low battery condition and the

need for a fresh battery. Continued use will further deplete the battery eventually causing the LED to automatically

turn itself off and remain off until a fresh battery is installed.

To replace the battery, open the bottom battery door cover with your thumb, rotate the door until it is perpendicular with

the case and allow the battery to fall out of the compartment into your hand. Observe the large and small holes in the

battery contact pad before inserting a new battery. Insert the contact end of the battery first, making sure the contacts

are aligned with the holes in the contact pad, and then swing the door closed. You will feel it snap into place when it is

fully closed.

To open the battery

compartment door, push the

door up and away from the case

with your thumb, then swing

open.

Figure 4 - Battery Replacement

Hours Power LED

1 Solid On

2 Solid On

3 Solid On

4 Solid On

5 Solid On

6 Blinks 90% on, 10% off

7 Blinks 50% on, 50% off

8 Blinls 10% on, 90% off

9 Off (Replace battery)

Figure 5 - UCR110 Approximate Battery Life with Alkaline Battery

Rio Rancho, NM – USA

1 2 3 4 5 6 7 8 9 10

No comments

Lectrosonics UCR110 User Manual Page 7