Lectrosonics UCR401 User Manual Page 12

  • Download
  • Add to my manuals
  • Print
  • Page
    / 28
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 11
UCR401
LECTROSONICS, INC.
12
Frequency Window
TVxx - The television broadcast channel the frequency
falls within.
Transmitter switch settings (AE
in the illustration) - These are the
correct settings for the frequency
switches on your transmitter - see
your transmitter instructions.
Frequency - Press the SEL Up and
Down buttons to change the frequency of the receiver.
Note: Be certain to change the transmitter
frequency switches to match the settings shown
in the upper right hand corner of the Frequency
window.
Menu Selections from Main Window
When the TUNING mode is set to NORMAL, the SEL
Up and Down buttons tune in single channel incre-
ments. In the GROUP tuning modes, the SEL Up and
Down buttons move among the selected intermod-free
frequencies.
Battery Level Window
This window shows the trans-
mitter (TX) and receiver (RX)
battery voltage. These levels will
flash when the voltages drop be-
low suggested optimum working
levels. Typically, there will be about one hour operating
time remaining after the indicators begin to flash. The
RX voltage changes to EX when operating on external
power and displays the external power source voltage.
(Disclaimer: We cannot guarantee 0.1 Volt accuracy.)
Frequency
Scan Mode
SELECT
Lock/Unlock
Pilot Off/On
Battery Level
Window
Frequency
Window
Main Window
P
r
e
s
s
M
E
N
U
P
r
e
s
s
M
E
N
U
P
r
e
s
s
M
E
N
U
P
r
e
s
s
M
E
N
U
Hold MENU & press UP
Press All Buttons
Press & Hold MENU
Press UP
Press
UP
Press UP
Press MENU
Setup Window
(Press UP / DOWN to adjust)
Level
Audio Te st To ne
Press MENU
(Press UP / DOWN to adjust)
Press MENU
Press MENU
Audio Test To ne
(Press UP / DOWN to select)
Tx Battery Ty pe
Press MENU
(Press UP / DOWN to select)
Output Phase
Press
UP
Press MENU
(Press UP / DOWN to select)
Press MENU
P
r
e
s
s
U
P
Noise Reduction
Press
UP
Press MENU
(Press UP / DOWN to select)
Press MENU
Tu ning Mode
Press
UP
Press MENU
(Press UP / DOWN to select)
Press MENU
Compatibility Mode
Press
UP
Press MENU
Press
MENU
Press
MENU
Press
UP
From the Main Window, you can navigate
to the Frequency, Battery Level and
Setup windows in a circular sequence by
pressing the MENU button.
Page view 11
1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 27 28

Comments to this Manuals

No comments