Lectrosonics Venue (Narrowband) User Manual download pdf (Page 11)

      

        

   

        

       

Digital Hybrid Wireless™ Modular Receiver System

Pressing the Receiver Select Button again will switch

to the receiver module information screen to show the

basic setup.

Press the BACK button twice to return to the overview

screen.

From the overview screen, press the MENU/SELECT

control to open the TopMenu, rotate the control to

select an item, then press the control to enter the setup

screen for that item.

In a setup screen such as the LockSet example shown

here, up/down arrows prompt you to change the setting

by rotating the MENU/SELECT control.

Up/Down

Arrows

When the desired setting or value is displayed, press

the MENU/SELECT control or BACK button to return to

the previous menu.

Selecting SetUpRx (set up receiver) in the TopMenu

will take you to another menu where all settings for the

receiver modules can be made.

Select an item with the MENU/SELECT control and

press the control to open the setup screen (“Level” in

this example).

Setup screens for the receiver modules display the

settings for the selected module and allow immediate

access to all modules by pressing the Receiver Select

Buttons. Receiver module 1 (Rx1) is selected in this

example with its output level set at -3 dBu.

Function

Button

If another option is available, it will appear in the left

hand section of the LCD (“TONE” in this example).

Press the Function Button to select and deselect this

option with repeated presses. The display will highlight

the option when it is selected.

NOTE: Settings take effect immediately and are

stored until changed again. Pilot Tone Bypass is

different in that it resets to the default value when

the power is cycled.

Please spend a few minutes with the navigation controls

to familiarize yourself before going through the setup

procedures. Details for each adjustment and setting

begin on the next page.

Resetting to Factory

Defaults

Resetting to Factory Defaults can be a time saver for

setting up the system. Start with the power turned off,

then hold Receiver Select Buttons 5 and 6 while power-

ing up the system.

POWER Switch

Receiver Select

Buttons 5 and 6

The Factory Default Settings are:

Level

+00 dBu

Phase

NORMAL

TxBatt

9V ALK

SmartNR

NORMAL

Compat

Dig. Hybrid

Tuning

NORMAL MODE

DivMode

Switched

LockSet

NOT LOCKED

RxCh

8,0

Rio Rancho, NM, USA

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 31 32

Comments to this Manuals

No comments

Lectrosonics Venue (Narrowband) User Manual Page 11

Comments to this Manuals

Related products and manuals for Equipment Lectrosonics Venue (Narrowband)