Lectrosonics T195 User Manual

UT195 HAND-HELD TRANSMITTER OPERATING INSTRUCTIONS and trouble-shooting guide LECTROSONICS, INC. Rio Rancho, NM

SPECIFICATIONS Operating Frequencies: 470 to 608 MHz RF Power Output: 50mW on VHF Pilot Tone: 32.768 kHz, ±2 Hz, 5kHz deviation Frequency Stabilit

Hand-held Transmitter SERVICE AND REPAIR If your system malfunctions, you should attempt to correct or isolate the trouble before concluding that th

LIMITED ONE YEAR WARRANTYThe equipment is warranted for one year from date of purchase against defects in materials or workmanship provided it was pur

INTRODUCTION Thank you for selecting the Lectrosonics T195 hand-held wireless transmitter. The T195 combines over 80 years of engineering experienc

Hand-held Transmitter GENERAL TECHNICAL DESCRIPTION The T195 / UT195 transmitter is comprised of a number of functional sub-systems as shown in the b

The 195 system utilizes a separate ultrasonic tone modulation of the basic carrier to operate the receiver squelch. A 32kHz tone is injected into the

Hand-held Transmitter EXTERNAL SWITCHES BYPASS This concealed slide switch defeats the external switches on the bottom panel for applications where

BASS FILTER In addition to the tone controls, the UT200 also has a built in bass filter. This filter is fixed and cannot be adjusted or defeated.

Hand-held Transmitter BATTERY INSTALLATION The transmitter is powered by a standard alkaline 9 Volt battery. It is important that you use ONLY an A

OPERATING INSTRUCTIONS 1) Install a fresh battery according to the instructions on page 5. Leave the battery cover off for further adjustment. 2)

Hand-held Transmitter TROUBLESHOOTING Before going through the following chart, be sure that you have a good battery in the transmitter. It is import