Lectrosonics Pro 4 Channel User Manual download pdf (Page 6)

INSTALLATION

The PRO4 CHANNEL is designed to contain up to four receivers. Installation of these receivers is quite simple.

First, place the entire assembly face down on a firm surface and remove the large phillips head screws which hold

the mounting brackets at the rear of the unit. (See Figure 3) Place the receiver(s), front end first against the front

panel. Seat the front end of the receiver into the recessed lip of the PRO4 CHANNEL front panel. The rear panel

of the receiver will extend the same amount as the rear panel of the DM4 module when the unit is properly seated.

Repeat this for each receiver to be installed. After each receiver is in place, install the mounting brackets with the

large phillips head screws to the mounting posts.

At the rear of the unit, attach the antenna leads to each receiver, making sure the BNC connector is securely

twisted and locked into place. The Diversity model will have two antenna leads for each receiver. Be sure to

connect the ANTENNA A plugs with the ANTENNA A jacks and the ANTENNA B plugs with the ANTENNA B jacks.

Set the power switch on the receivers to the ON position. Antenna leads serving empty slots can be left open, but

best performance will be had if they are terminated with 50 Ohms.

At the rear panel, insert the power connectors into the power jack of each receiver.

OPERATING INSTRUCTIONS

After all the receivers have been installed, check to be sure that the receivers have their power switch set to ON.

Audio leads should be balanced audio cables leading to the mixer or recorder.

Turn the system on by switching the power switch on the DM4 module to ON. The power indicator LEDs should

light on all the receivers and the DM4.

Operate the wireless microphone according to the instructions included with the systems.

1 2 3 4 5 6 7 8 9 10

No comments

Lectrosonics Pro 4 Channel User Manual Page 6