Lectrosonics SRb_SRb5P User Manual download pdf (Page 17)

UHF Digital Hybrid Wireless

Rio Rancho, NM

TUNING

InadditiontotheNOR(normal)mode,thisscreenalso

allowsSelectionofoneoffourfactorypre-selected

frequencygroups(Groupsathroughd)ortwouser

programmablefrequencygroups(Groupsuandv).

• NORallowsselectionofall256frequenciesthatthe

receiverwilltune.EachpressoftheUPorDOWN

buttonwillstepin100kHzincrementstothenext

frequency.

• a, b, c, d sets the receiver to tune only factory

preselectedfrequencies,uptoeightineachgroup.

EachpressoftheUPorDOWNbuttonwillstepto

thenextfrequencyinthegroup.

• u, vallowupto16user-selectedfrequenciesto

bestoredineachgroup.EachpressoftheUPor

DOWNbuttonwillsteptothenextstoredfrequency

inthegroup.

Note:TheTuningSetupScreenonlyselectsthe

tuningmode(NORMALorGroupTuning).Actual

operatingfrequenciesarechosenthroughthe

Frequency Screens.

USINGTHEGROUPTUNINGMODES

PressMENUtoselectreceiver1or2.

Whenatuninggroupis

Selected,aletterwillappear

next to the hex switch settings.

640.500

HoldingtheMENU/SELbuttonwhilepressingtheUPor

DOWNbuttonwillsteptothenextfrequencyin100kHz

steps,whichwillselectafrequencythatisnotstored

inthegroup.Inthiscase,thegroupletterinthedisplay

will blink to indicate that the selected frequency is not

includedinthegroup.

The letter will blink when

a frequency outside of the

tuninggroupisSelected.

640.500

Whennofrequenciesarestoredingroupsuandv,the

UPandDOWNbuttonswillfunctionthesameasin

theNORMALmode(eachpressmovesupordownin

100kHzsteps).

Whenonlyonefrequencyisstoredingroupuorv,the

UPandDOWNbuttonswillnotchangethefrequency.In

thiscase,holdtheMENU/SELbuttoninandthenpress

UPorDOWNtoscrolltothedesiredfrequency.

Toaddafrequencytotuningeithergroupuorv,Select

thedesiredfrequency,thenholdtheMENU/SELbutton

in and then hold the UP orDOWNbuttoninuntilthe

letterstopsblinking.

To delete a stored frequency, select it with the UP and

DOWNbuttons,thenholdtheMENU/SELbuttonin,

then hold the UP orDOWNbuttoninuntiltheletter

starts blinking.

SmtNR

ThissetupscreenisavailableonlyintheDigitalHybrid

COMPAT(compatibility)mode.Selectthedesiredmode

while listening to the audio to of one of three choices:

• OFFprovidesnonoisereductionforcomplete

transparency,whichisusefulincontrolledenviron-

ments with very little high frequency noise such as

anindoormotionpictureproductionset.

• NORMALappliesamoderateamountofnoise

reduction to noticeably reduce hiss from subtle

sourcessuchaselectretmicrophones.

• FULL is very similar to the Lectrosonics noise

reductionsystemusedformanyyearsinthe195

and200Seriesanalogsystems.Hissfromelectret

microphonesandsomeenvironmentalHFnoiseare

suppressed.

PHASE

Thissetupscreenallowstheaudiooutputphasetobe

invertedtocompensateforsituationssuchasphase

reversalcausedbymicrophonewiring.

TXBAT

ThissetupscreenallowsyoutoSelecttheexactbattery

beingusedinthetransmittertoprovidemoreaccurate

battery level monitoring.

WhentheCOMPATmodeissettoHYB(DigitalHybrid)

orthe200Seriesmode,thechoicesare:

• 9V-Transmitterusesa9Valkalinebattery.

• 9VL-Transmitterusesa9Vlithiumbattery(not

rechargeable).

• 9VT-Transmitterusesa9Vbatteryofanytype.

MonitoritsstatuswiththetimerintheLCDMain

Window. This is the best choice when using a re-

chargeable battery in the transmitter.

• AA-TransmitterusesaAAalkalinebattery.

• AAL-TransmitterusesaAAlithiumbattery(not

rechargeable).

• AAT-Transmitterusesanalkaline,lithiumorre-

chargeable AA battery. This is the best choice when

using a rechargeable battery in the transmitter.

IncompatibilitymodesotherthanDigitalHybridand

200Series,nobatterytelemetryinformationisavail-

able,sotheTXBATsetupscreenoffersonlytwo

choices:

• ---(notimer)-Displaynotransmitterbatterystatus

in the main window.

• TIM-Monitorthetransmitterbatterystatuswiththe

batterytimerintheLCDMainWindow.

NOTE:Toresetthetimer,settheTXBATmodeto

anythingotherthan9VTorAAT,thenbacktothe

desired mode.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 27 28

Comments to this Manuals

No comments

Lectrosonics SRb_SRb5P User Manual Page 17

Comments to this Manuals

Related products and manuals for Equipment Lectrosonics SRb_SRb5P