Lectrosonics SMa User Manual download pdf (Page 16)

 

  

 

SMa Series

RM Remote Control Operating Instructions

Important: The remote control (RC) mode must

be enabled on your SM Series transmitter for

the RM to function with it. For instructions,

refer to page 8 of this publication.

RM Front Panel Controls

The RM unit gives you remote control of SM Series

transmitters using an audible tone delivered to the

transmitter’s microphone. Operating parameters on the

transmitter can be set by holding the speaker on the

RM close to the microphone and pressing the pushbut-

ton. A “dweedle” tone will play from the RM speaker into

the microphone and the parameter on the transmitter

will be set immediately.

Available adjustments:

• Audio input gain

• Frequency

• Lock or Unlock Modes

• Sleep Mode ON/OFF

When an SM Series Transmitter is in the power sav-

ing sleep mode, it uses only 20% of the normal bat-

tery drain, so battery life with be 5 times longer. This

is especially useful in situations where the transmitter

is buried deep inside costuming and there are wait-

ing periods between use. The transmitter can “sleep”

for several hours and then be awakened and adjusted

when the production is about to begin.

Powering the RM on and off

To turn the RM on or off, press the AUDIO and FREQ

buttons together brieﬂy. The unit powers up on the page

that was displayed when the unit was powered off last.

Principles of Operation

The RM user interface is organized into pages which

are accessible via the AUDIO and FREQ buttons. Once

on a page, settings can be adjusted with the UP and

DOWN arrow buttons.

To change a transmitter’s setting via the RM, it is neces-

sary to dial in the new setting on the appropriate page

on the RM, and then press the SEND button (on the

side, near the speaker). The speaker should be uncov-

ered and held within a few inches of the transmitter’s

microphone. (The longest usable range is about 6 feet,

depending on the microphone and volume settings

used.)

A single AA Lithium battery will operate

the RM for up to several years.

NOTE: Only the speciﬁc function displayed is

altered. For example, if the remote control is on the

CH (channel) screen, pressing the send button will

set the transmitter’s channel but will not affect any

other setting on the transmitter at that time.

RM Pages

The AUDIO button cycles through 4 pages:

1) Aud - set transmitter’s audio level

2) SLEEP/unSLP - cause transmitter to sleep or wake up

3) Loc/unLoc - lock or unlock transmitter’s buttons

4) Loud - adjust RM speaker volume

(press SEND button for a sample tone)

The FREQ button cycles through 2 or 3 pages, depend-

ing on the settings:

1) CH - set transmitter’s channel

(using block-independent hex code)

2) b - select a block number

(optional — uncovers next page)

3) 000.000 - set transmitter’s frequency in MHz

(avail. if a block is selected)

Speaker

Send Button

When the SEND button is pressed, the selected RM setting is

transmitted via the RM speaker to the microphone attached to

the SM Transmitter.

LECTROSONICS, INC.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22 23 24

Comments to this Manuals

No comments

Lectrosonics SMa User Manual Page 16

Comments to this Manuals

Related products and manuals for Accessories communication Lectrosonics SMa