Lectrosonics UT200c User Manual download pdf (Page 10)

ADJUSTING THE TRANSMITTER FREQUENCY

If you are experiencing interference from another signal on your frequency, you may want to change the operating

frequency of your system. The switch nearest to the mic element changes the operating frequency by 100 kHz per

step and the switch furthest from the mic element changes it 1.6 MHz per step. If you are experiencing interference,

change the operating frequency of the receiver to find a clear channel, then set the transmitter to match.

Note: These switches also appear on the front panel of the

UDR200A version of the studio receiver and on the rear panel of

the UCR200D version of the compact receiver. Normally, you

should set the transmitter switches to match the receiver switch

settings.

With the UDR200B version of the studio receiver, the front panel

1.6M

100K

LED character display will indicate the correct transmitter switch

Frequency Switches

settings.

To gain access to the Frequency Switches, pull the access door straight out. It is held in place magnetically. There is

a “doorknob” provided for gripping.

Frequency Switches

100 kHz 1.6 MHz

Magnetic Door

Door Knob

UT200C Internal Controls

1 2 ... 5 6 7 8 9 10 11 12 13 14

No comments

Lectrosonics UT200c User Manual Page 10