Lectrosonics Long Ranger III User Manual download pdf (Page 4)

CONTROLS AND FUNCTIONS

CONTROL PANEL

WIRELESS MICROPHONE VOLUME

Turns unit power on and off and also functions as the volume control for the internal wireless receiver.

POWER

A red LED that lights when unit power is on.

A green LED that lights when the companion transmitter is turned on and there is sufficient signal for good system

operation. Internal circuits monitor both signal level and interference levels and decide if the transmitted signal is

strong and “clean” enough for satisfactory operation. If not, the green RF LED will go out and the receiver will

“squelch”, shutting off the sound output. This action is automatic and requires no user adjustment.

MOD LEVEL

The red and green MOD LEVEL LEDs continuously indicate the modulation level(audio level) of the received signal

from the transmitter and are used when making initial adjustments to the transmitter.

MIC

This jack is a standard 1/4" phone jack and is used for plugging in the cord from a dynamic microphone such as the

Lectrosonics M121S.

LINE

This mini jack is used for connecting high level, high impedance outputs from tape decks or other amplifiers. It also

may be used for connecting the “earphone” output from portable cassette players.

AUXILIARY INPUT VOLUME

Adjusts the volume of the MIC and LINE inputs.

AUX IN/OUT

An RCA phono jack that functions both as a line level input and line level output. This “omnibus” jack is primarily used

for interconnecting several LONG RANGER IIIs together for simultaneous operation. This jack can also be used with

a tape deck to either record from or play back into the LONG RANGER III. When used with a tape deck or other

audio source, the sound output level must be controlled by the volume control on the tape deck since there is no

volume control on the LONG RANGER III for the AUX IN/OUT jack. When an external device is connected to this

jack, the loudness of the Long Ranger III will usually be reduced.

CH-40

A special jack used for connecting the CH-40 charger when charging the battery pack. The green LED located under

the jack lights when the batteries are charging. This LED automatically goes out when the batteries are almost fully

charged.

12V DC OUTPUT

A special jack used to supply power to the Add-On receiver when that option is installed.

1 2 3 4 5 6 7 8 9 ... 15 16

No comments

Lectrosonics Long Ranger III User Manual Page 4