Super-Minature Belt Pack Transmitter
Rio Rancho, NM
17
Operating Notes
• Thesensitivitytotheremote
control varies with the trans-
mitter’s audio level setting
and the microphone used, but
it is always possible to make
it work with a sufficiently loud
remote signal at close range.
• Ifthetransmitteriscongured
to respond to the remote
control, it will do so even if
the buttons are locked.
• Whenthetransmitteris
asleep, it can only be awak-
ened by the remote control,
or by removing and reinsert-
ing the battery.
• Whenthetransmitteris
asleep,thePWRledblinks
green every few seconds.
• Ifaremotecommandissentthatwouldresultin
the same display being shown again on the trans-
mitter (for example tuning to the channel already
displayed), a row of dashes is displayed briefly, as a
signal that the command was received, but it didn’t
change anything.
• Ifyouarehavingtroublegettingthetransmitterto
respond, make sure you aren’t covering the speaker
with your thumb, and/or turn up the speaker volume
on the Loud page.
• IftheRMissettoadifferentblocknumberthan
the transmitter and an attempt is made to set the
transmitter’sfrequencyinMHz,thecommand
will still work. The transmitter is simply set to the
corresponding channel in the correct block, with a
matching hexadecimal number.
• TheaudiosignalfromtheRMwillchangetheset-
tingsofalltransmitterswithinrange.Experiment
with this to prevent accidental changes to another
transmitter during a production.
RM Quick Reference
PowerOn/Off AUDIO+FREQ
SetSMQVaudiolevel Audpage(viaAUDIO)
SleeporWakeSMV SLEEP/unSLPpage(viaAUDIO)
Lock or Unlock SMV Loc/unLoc page (via AUDIO)
Adjust RM volume Loud page (via AUDIO)
SetSMQVchannel(hex) CHpage(viaFREQ)
EnableMHzdisplay b(block)page(viaFREQ)
SetSMQVchannel(MHz)000.000page(viaFREQ)
The RM should be held close enough to the microphone to
change the settings on the intended transmitter, and not be
loud enough to affect other transmitters nearby.
RM2 Remote Control
A lower cost alternative to the RM, this model provides
remote control of:
• Sleep/Unsleep
• Lock/Unlock
• AudioLevel(gain)
This model operates on a “button cell” battery with a
recessed trim pot (screwdriver adjusted) for the speaker
level control.
Important: The remote control (RC) mode must
be enabled on your SM Series transmitter for
the RM to function with it. For instructions,
refer to page 7 of this publication.
Comments to this Manuals