Lectrosonics EQ1_EQ2 User Manual download pdf (Page 6)

Pop Suppress Threshold - Allows adjustment of the amount of DPS action. Threshold range is -40dB to 0dB. A

dynamic display of the amount of DPS activity is included in this screen to help in the adjustment process.

Display Contrast - Allows the contrast ratio of the LCD display to be adjusted to accommodate different viewing

angles.

Auto Equalize... - Initiates the AutoEQ

process. Note that the Target Curve/Target Input Source used for the

AutoEQ

process is the one that has been selected by the Adjust Target Curve menu item. If the SELECT

button is pressed, the AutoEQ

process will begin. First, the Pink Noise Level menu item will be displayed. Use

the UP and DOWN buttons to adjust the noise level to an appropriate measurement range. Prompts on the

display will indicate when the noise level is adequate. The SELECT button is pressed again to start the actual

AutoEQ

. The Checking Band screen will then be shown, and will indicate how far along the AutoEQ

process

is. At the end of the process, the display will revert to the Auto Equalize... menu. Remember that the SAVE

button must be pressed after the AutoEQ

process to store the new EQ curve to permanent memory.

REAR PANEL DESCRIPTION

OUT

EXPANSION

EQ OUT

+ –

LECTROSONICS, INC.

LecNet

(RS232)

EQ THRU

+ –

REF MIC IN

+ –

EQ IN

+ –

PWR IN

(CH40)

20 VAC

EQ1/EQ2 Rear Panel

EQ IN - Provides the balanced, RF protected line level input into the EQ1/EQ2.

EQ THRU - Provides an output directly in parallel with EQ IN. Note that if EQ IN is used unbalanced, EQ THRU will

also be unbalanced.

REF MIC IN - Provides the balanced, RF protected reference mic input into the EQ1/EQ2. +15V phantom power is

provided to this input.

EQ OUT - Provides the balanced line level output of the equalizer.

LecNet

(RS-232) SERIAL PORT - Provides access to and control of some of the operational features of the EQ1/

EQ2. The port is compatible with the serial port of a PC, or other controllers with RS-232 type serial ports. For

hardware interconnection and software details, see Appendix 1, “Serial Port Hardware and Software”.

EXPANSION IN/OUT - Connects the EQ1/EQ2 to other LecNet

compatible devices. The Expansion connection to

the EQ1/EQ2 is only necessary if the device is used with a computer. The EQ1/EQ2 Expansion Out port should be

connected to the last LecNet

in the chain (see Figure 2 above).

PWR IN - Connects to the CH40 power supply to provide power for the EQ1/EQ2.

1 2 3 4 5 6 7 8 9 10 11 ... 15 16

Comments to this Manuals

No comments

Lectrosonics EQ1_EQ2 User Manual Page 6

Comments to this Manuals

Related products and manuals for Audio accessories Lectrosonics EQ1_EQ2