Lectrosonics Quadra User Manual download pdf (Page 24)

QUADRA

Single Unit Rack-Mount

Instructions

Optional RMPM4T-1 Kit

This kit is required to rack mount a single transmitter.

Assembling the optional RMPM4T-1 kit:

1. Remove the plastic end-caps from the front of the

M4T transmitter. Pry out the metal inserts on each

side of the transmitter with a small screwdriver

Plastic guards snap out

from corners. Pry out the

aluminum inserts on the

side panel with a small

screwdriver.

2. Attach the antenna cable to the rack ear with the

supplied nut and lock washer. Tighten with a small

wrench - do not over-tighten the nuts but make

sure they are snug enough not to work loose. In-

sert the rack ear into the left side of the transmitter

front panel.

3. Insert the rack ear and attach the handle to the

front of the panel using the supplied hex-head

bolts and hex wrench. The screws should go

through the handle, through the front panel, and

into the rack ear nuts. Tighten these bolts ﬁrmly.

4. Attach front bracket plate to right side of panel.

Insert the screws

partially, but do not

tighten them yet.

5. Attach the blank panel to the bracket and tighten

all four screws.

The threads in the front

adapter plate are a self-

locking type. Tighten the

screws until the heads are

ﬂush with the front panel.

6. Remove the rear panel hex head screws and

mount the steel brace to the rear panel. Do not

tighten the screws yet.

7. Attach the steel brace to the blank panel using the

supplied screws. Tighten all four screws that retain

the brace.

Install handle and bracket

with supplied screws

8. Tighten all the hex head screws snugly.

LECTROSONICS, INC.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 30 31 32

Comments to this Manuals

No comments

Lectrosonics Quadra User Manual Page 24

Comments to this Manuals