Lectrosonics UDR300c User Manual download pdf (Page 23)

Wireless Diversity Receiver

Set Lock Status - Sets the front panel lock status of the receiver.

Host sends command - 7 (7 hex)

Host sends data byte - 0=hard locked, 1=not locked, 2=locked

Get Lock Status - Gets the front panel lock status of the receiver.

Host sends command - 8 (8 hex)

Host receives data byte - 0=hard locked, 1=not locked, 2=locked

Set Channel Group - Selects the active channel group.

Host sends command - 9 (9 hex)

Host sends data byte - 1-4 selects group 1 thru 4

Get Channel Group - Reads the active channel group.

Host sends command - 10 (A hex)

Host receives data byte - 1-4 indicates group 1 thru 4

Get Firmware Revision - Reads the firmware revision.

Host sends command - 25 (19 hex)

Host receives data byte - firmware revision times ten (e.g. 10 for rev 1.0)

Get Optiblend Status - Retrieves dynamic diversity system status information.

Host sends command - 28 (1C hex)

Host receives 2 bytes - analog optiblend values (0-255) for antennas A and B

Set Remote Mode - Places receiver in a mode suitable for serial remote control (or restores normal operation

afterwards). In remote mode, a text message is displayed on the receiver’s front panel display and the front

panel buttons will not operate the receiver.

Host sends command - 30 (1E hex)

Host sends byte - 0 for normal mode, 3 for remote mode

If remote mode is selected, Host Sends 13 more bytes containing the text to be displayed on the receiver’s

alphanumeric display.

Get Pilot Bypass - Retrieves the status of the pilot tone bypass feature.

Host sends command - 53 (35 hex)

Host receives data byte - 0=not bypassed, 1=bypassed

Set Pilot Bypass - Sets the status of the pilot tone bypass feature.

Host sends command - 54 (36 hex)

Host sends data byte - 0=not bypassed, 1=bypassed

Rio Rancho, NM – USA

1 2 ... 18 19 20 21 22 23 24 25 26

No comments

Lectrosonics UDR300c User Manual Page 23