Lectrosonics VRFIELD (Narrowband) User Manual download pdf (Page 16)

VR Field

Installing LecNet2

™

Software and USB Driver

Part of the LecNet2

™

software package is the VRpanel

for the VR Field Receiver. This Graphical User Interface

(GUI) is designed to allow easy setup and monitoring of

the VR Field Receiver using a computer system running

the Windows

2000 or XP operating system.

Installing LecNet2

™

Software

1. Remove any previously installed versions of Lec-

Net2

™

software. (This will ensure you are using the

latest release.)

2. Insert the LecNet2

™

program disk supplied with the

VR Field Receiver into the CD-ROM drive on the

computer system that will be used to set up and

control the VR Field Receiver.

3. The CD should automatically start the installation

procedure. If it doesn’t, click “Start” on the Windows

Task Bar then click “Run...” Enter the Drive letter

(“E” in the example) followed by “Setup.exe” as

shown below.

4. Follow the on-screen instructions to install the Lec-

Net2

™

software and the VR Panel for the VR Field

Receiver.

Installing the LecNet2

™

USB Driver

There are two ways to connect a Windows

-based com-

puter system to the VRF: a USB cable or an RS-232

cable. Although the USB port offers increased speed

and convenience over standard RS-232 links, it does

require the installation of a LecNet2

™

USB driver.

The LecNet2

™

USB driver is not part of the standard

Windows

2000 and XP driver libraries; therefore, con-

necting a computer system to the VR for the ﬁrst time

differs from subsequent installations. There are a few

differences between installing the LecNet2

™

USB driv-

ers on Windows 2000 versus Windows XP systems.

USB Driver Installation (Windows XP) - First Time

When the VR is connected to a Windows XP computer

system for the very ﬁrst time, the Windows

Found New

Hardware Wizard automatically opens. Use the follow-

ing procedure to install the LecNet2

™

USB driver using

the Wizard.

1. Place the LecNet2

™

Installation Disk in the PC’s

CD-ROM drive.

2. On the ﬁrst page of the Wizard, select Install from

a list or speciﬁc location (Advanced) and click

“Next>” to continue.

3. Select “Search for the best driver in these loca-

tions.”, then check the box for “Search removable

media (ﬂoppy, CD-ROM...)” and click Next> to

continue to the next page..

LECTROSONICS, INC.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 27 28

Comments to this Manuals

No comments

Lectrosonics VRFIELD (Narrowband) User Manual Page 16

Comments to this Manuals

Related products and manuals for Equipment Lectrosonics VRFIELD (Narrowband)