Lectrosonics VRFIELD (Narrowband) User Manual download pdf (Page 8)

VR Field

Hardware Installation

Installing/Removing Receiver Modules

Up to six Receiver Modules can be installed in a VRF

chassis. These modules may be installed at the factory

or added later.

Although the VR Field System is quite ﬂexible, any com-

bination of Receiver Modules installed must be within

the frequency block range of the VRF chassis. The

frequency block range of the VRF chassis is displayed

during the PowerUp Sequence.

Frequency Block Range

Installing Receiver Modules

1. Ensure the VR Field System is turned off and the

power source has been disconnected. Slide the

Receiver Module Connector ﬁrmly onto the Receiv-

er Module Tab.

Caution: Do not force the Receiver Module

onto the Receiver Module Tab. If the module

does not seat properly, look to see if its

position is a little off. Excessive force may

damage the module’s connector or the

Receiver Module Tab.

2. Install a Receiver Module Retaining Clip between

the rear of the Receiver Module and the Module

Tab. Ensure this clip is ﬁrmly snapped into place.

Receiver Modules

Receiver Module Tabs

Receiver Module Receiver Module

Retaining Clips Connectors

Bottom View of the Chassis

VRF Front Panel

VRF Rear Panel

Removing Receiver Modules

1. Ensure the VR Field System is turned off and the

power source has been disconnected.

2. Remove the Receiver Module in the reverse order

of installation, i.e., remove the Receiver Module Re-

taining Clip, then slide the module off the Receiver

Module Tab and remove it from the VRF chassis.

Installing the VR Field System

The VR Field Receiver is designed for portable use, as

in a bag system.

1. Position the unit for easy access to the panel con-

trols and connections. There are no special ventila-

tion requirements.

2. Connect the antennas (or antenna cables if remote

antennas are being used) to the antenna input con-

nectors on the rear panel of the VRF.

Coaxial Cables

Antenna

Inputs

3. For multiple unit installations, connect coaxial patch

cables from the Antenna A and B OUT jacks on the

rear panel of the ﬁrst unit to the Antenna A and B IN

jacks on the second unit. An additional unit can be

connected to the second unit in the same manner.

Note: All units connected in this manner must be on the same

frequency block.

LECTROSONICS, INC.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

Comments to this Manuals

No comments

Lectrosonics VRFIELD (Narrowband) User Manual Page 8

Comments to this Manuals

Related products and manuals for Equipment Lectrosonics VRFIELD (Narrowband)