Lectrosonics UT200 User Manual download pdf (Page 5)

Frequency Agile Handheld Transmit-

ter

CONTROLS AND FUNCTIONS

EXTERNAL

“P” SWITCH – POWER ON/OFF

Audio Power

A slide switch which turns battery power on and off. The LED next to the switch lights up when the “P”

switch is turned on. This LED also serves as a battery condition indicator. The LED will glow brightly

when the battery is good and will dim as the battery condition deteriorates. The LED is at full brightness

with a new battery. When the battery voltage reaches 7 Volts, the LED will be completely dark. Note: this

LED will not light if the EXT LED switch is in the OFF position.

On/Off On/Off

“A” SWITCH – AUDIO ON/OFF

A slide switch which “mutes” the audio in the OFF position and allows the audio gain (modulation level) of the transmit-

ter to be adjusted without feedback from the sound system. This switch will do nothing if the EXTERNAL SWITCHES

switch is in the BYPASS position.

INTERNAL

FREQUENCY ADJUST

Two rotary switches adjust the center frequency of the carrier. The

1.6M is a coarse adjustment and the 100K is the fine adjustment.

Each transmitter is factory aligned at the center of its operating

range. The default position of the frequency select switches is in the

center of the transmitter’s range. See page 10 for details on adjust-

ing the transmitter frequency.

MOD LEVEL LEDs

Frequency switches

located behind door.

These LEDs (loacted under the battery door) indicate the audio input level and are used

Mod Level

LEDs

when adjusting the transmitter AUDIO LEVEL (gain) control. As the audio level increases,

first one LED lights. The other LED lights as the audio level reaches maximum modulation.

The LEDs are located underneath the battery cover, next to the AUDIO LEVEL control and

are easily viewed when holding the transmitter in a normally used position.

AUDIO

LEVEL

Gain Control

AUDIO LEVEL

This knob (also located underneath the battery door) is operated while speaking or singing into the transmitter to

adjust the audio gain of the transmitter for the correct amount of modulation. The LEDs located next to it indicate the

modulation level as the gain is adjusted. See page 6 for details on this very important adjustment.

EXTERNAL SWITCHES BYPASS

This concealed slide switch defeats the external switches on the bottom panel for applica-

Bypass Switches

tions where it is best that the user not be able to operate the power and mute switches. The

external switches are bypassed when this switch handle is moved toward the bottom of the

unit.

EXTERNAL LED OFF

EXTERNAL

SWITCHES

BYPASS

EXTERNAL

LED

OFF

This slide switch defeats the battery status LED on the bottom panel for applications where

the LED may be distracting. With this switch in the right-hand position, the power will remain

on and the transmitter operating, even though the power LED is off. The external LED is

disabled when this switch handle is moved toward the bottom of the unit.

Rio Rancho, NM - USA

1 2 3 4 5 6 7 8 9 10 ... 13 14

Comments to this Manuals

No comments

Lectrosonics UT200 User Manual Page 5

Comments to this Manuals

Related products and manuals for Accessories communication Lectrosonics UT200