D4T/D4R
LECTROSONICS, INC.
10
Receiver
General Settings
Tuning Selection
Use UP/DOWN
arrows to select
menu item and
press FUNC to
enter setup
Use UP/DOWN
arrows to select
frequency, then
press FUNC to
return to menu
Audio Level
Use UP/DOWN
arrows to select
menu item and
press FUNC to
enter setup
NOTE: The setup screens for audio level will
bedifferentdependingupontheAES3Mode
selected. See the next page for details.
Calibration Tone
A steady tone at the maximum level before clipping
can be turned on at each output to allow accurate
inputleveladjustmentoftheattachedmixer,recorder
or other connected equipment.
While the tone level is always the maximum before
clipping,theaudiooutputlevelmaybeadjustedonany
analogoutput.Anyadjustmentsmadetotheanalog
output levels here are automatically applied to the
audio level setup screen as well.
The Calib. Tone menu item accesses a setup screen
which looks and operates the same way as the audio
level setup screen. The difference is that a 1 kHz tone
is produced at all outputs at the level shown.
Use UP/DOWN
arrows to select
menu item and
press FUNC to
enter setup
1 2 3 4
Press the button under the analog channel
to be adjusted and then use the UP and
DOWN buttons to set the desired level.
AES3 Modes
Use UP/DOWN
arrows to select
menu item and
press FUNC to
enter setup
Use UP/DOWN
buttons to select
desired mode
2/4 Channel Modes
Use UP/DOWN
arrows to select
menu item and
press FUNC to
enter setup
Use UP/DOWN
buttons to select
desired mode
Comments to this Manuals