Lectrosonics UM200c User Manual download pdf (Page 14)

UM200C

SPECIFICATIONS AND FEATURES

Operating frequencies: 537.600 to 607.900 MHz

614.100 to 767.900 MHz

Frequency selection: 256 frequencies in 100kHz steps

RF Power output: 100 mW (nominal)

Pilot tone: 32.764 kHz (± 2Hz); 5kHz deviation

Frequency stability: ± 0.002%

Deviation: ± 75 kHz (max)

Spurious radiation: 90 dB below carrier

Equivalent input noise: –126 dBV

Input level: Nominal 2 mV to 300 mV, before limiting.

Greater than 50V maximum, with limiting.

Input impedance: Taps provided for 500, 1k, 10k Ohm

Input compressor: Soft compressor, >30 dB range

Gain control range: 43 dB; semi-log rotary control

Modulation indicators: Dual LEDs indicate modulation level 12dB below

limiting and at the onset of limiting.

Low frequency roll-off

adjustment: –18dB/octave; 35Hz to 150Hz

Controls: 2 position “OFF-ON” slide switch for noiseless turn on/turn off operation.

Front panel knob adjusts audio gain. Recessed control on side panel

adjusts low

frequency rolloff. Rotary switches on side panel adjust transmitter frequency.

Audio Input Jack: Switchcraft 5 pin locking (TA5F)

Antenna: Detachable, flexible wire supplied. 50 Ohm port allows

connection to test equipment.

Battery: Precision compartment auto-adjusts to accept any known alkaline 9 Volt

battery. (We’ve tried 125 different ones!)

Battery Life: 4.5 hours (alkaline); 14 hours (lithium)

Weight: 6.3 ozs. including battery

Dimensions: 3.1 x 2.4 x .75 inches

Emission Designator: 180KF3E

Specifications subject to change without notice.

LECTROSONICS, INC.

1 2 ... 9 10 11 12 13 14 15 16

No comments

Lectrosonics UM200c User Manual Page 14