Lectrosonics UMCWB User Manual download pdf (Page 7)

UHF Diversity Multicoupler

Rio Rancho, NM 7

6. The power cables can be routed outside of the U-

channel cover, or routed under the U-channel cover

alongside the antenna leads.

Note: If you opt to run the power cords outside of

the U-channel along the back of the receivers, they

might be unplugged accidentally.

Installing the Wire Cover

Installing the U-channel wire cover can be difﬁcult if the

power cables are routed with the antenna leads under

the U-channel wire cover. The cables must lay ﬂat and

straight, and not overlap to allow the wire cover to lay

ﬂush with the rack mount. The technique described here

is the easiest way to install the U-channel wire cover,

A) Dress the antenna and power cables so that the

bundle is as ﬂat as possible. Make sure no wires

are on top of the metal bar.

B) Starting at the end opposite the power supply, care-

fully place the U-channel wire cover over the wiring

bundle and press down.

C) While keeping downward pressure on the U-chan-

nel, slide it to the left over the wire bundle.

D) As you move the U-channel across the bundle,

dress the cables with your other hand to make sure

the wires remain as ﬂat and neatly aligned as pos-

sible. The power cords in particular need to lie ﬂat

and not overlap each other.

E) While holding the U-channel down, insert the four

phillips head screws and tighten them slowly while

watching the wires to make sure none are pinched.

Installing the Assembled Unit

Mount the assembled frame into the rack, connect the

antenna and an appropriate power supply. There are no

special ventilation requirements.

1 2 3 4 5 6 7 8 9 10 11 12

No comments

Lectrosonics UMCWB User Manual Page 7