Lectrosonics DNTBOB 88 User Manual download pdf (Page 7)

Installation and Quick Start Guide

Rio Rancho, NM

Dante

Software

Installation

Bonjour Print Services (for Windows only)

Download the Bonjour Print Services for Windows

installer into a temporary folder on your PC.

http://support.apple.com/kb/DL999

Double click on the ﬁle to open the installer. If the

Security Warning dialog box opens, click on Run to

launch the installer and follow the on screen prompts.

Set Up Audinate Account and Download the

Dante Controller Installer

Set up an account with Audinate to gain access to the

free Dante Controller software. Click on Login at the

top of the screen and the forms page will open.

http://www.audinate.com

After your account is set up, return to the home page

and click on Support->Software Downloads->Dante

Controller. Log In on the next page and follow the on

screen prompts to download the installer and store the

ﬁle on your local drive.

Install Dante Controller

NOTE: Install Bonjour Print Services for

Windows before installing Dante Controller.

Double click on the downloaded ﬁle to open the in-

staller. If the Security Warning dialog box opens, click

on Run to launch the installer and follow the on screen

prompts.

Initial Setup

It is best practice to conﬁgure all units to operate in the

Switched mode to simplify initial settings.

Connect each BOB 88 unit to a computer directly or

via a network one at a time. Launch Dante controller

and then double click on the name of the unit to open

the Device View dialog box. Click on the Network

Conﬁg tab and select the Switched mode.

Set unit to

Switched mode

for initial setup

In the switched mode, either the Primary or Secondary

Dante port can be used interchangeably since each

port includes and Ethernet switch.

NOTE: Connect only one or the other. If both

ports are connected to the same network in the

switched mode, you will not be able to control

them with Dante Controller software.

Changing from Switched to Redundant Modes

When the units are changed from the Switched mode

to the Redundant mode (and vice versa), they must be

rebooted to enable and store the setting. It is generally

best to make this change when connected individually

to each unit. After the setting is changed, disconnect

the power and then reconnect it to reboot the unit.

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Comments to this Manuals

No comments

Lectrosonics DNTBOB 88 User Manual Page 7

Comments to this Manuals

Related products and manuals for Audio accessories Lectrosonics DNTBOB 88