Lectrosonics R172 User Manual download pdf (Page 8)

3) CONNECT THE AUDIO CABLE/S

If the receiver will be connected directly to an amplifier and there is only one audio input available, set the

SEPARATE/MIXED

switch to the mixed position and connect the cable to either the "A" or "B" output jack.

You may also used the MIXED position to connect the receiver to a tape deck and an amplifier for

simultaneous recording. See the illustration below.

If the receiver will be connected to a mixer or an amplifier with two (or more) audio inputs, then set the

switch to

SEPARATE

. By doing so, the audio signals will be separate and can be adjusted independently

at the mixer or amplifier. Connect the receiver with two cables to the amplifier or mixer.

Figure 5 Audio Connections

4) SET FRONT PANEL SWITCH TO "ON" POSITION

- Be sure the POWER LED lights.

5) ADJUST TRANSMITTER "MIC LEVEL"

(See transmitter manual)

This is perhaps the most important step in the set up procedure. See your transmitter manual for specific

instructions on the proper gain adjustment of your transmitter. With some transmitter models you will

need to observe the

MODULATION

LED's on the receiver front panel as you adjust the gain on the

transmitter.

6) SET THE OUTPUT LEVELS

- Set the front panel controls for

OUTPUT LEVEL

on each channel to the

NORMAL

" (at the 3 o'clock position)

7) ADJUST THE SOUND SYSTEM VOLUME

1 2 3 4 5 6 7 8 9 10 11 12 13

No comments

Lectrosonics R172 User Manual Page 8