Lectrosonics Venue Series (Wideband) User Manual download pdf (Page 6)

Venue Wideband Receiver

LECTROSONICS, INC.

POWER Button

Headphone LEVEL Control

PHONES Jack

Receiver Select

Buttons

Function Button

(labeled by the LCD)

BACK Button

PUSH FOR

MENU/SELECT

Rotary Control

The Venue receiver master unit (VRM) serves as a

“host assembly” for up to six receiver modules. The

standard module (VRS) and tracking module (VRT) can

be mixed and matched in the assembly in any combina-

tion to suit the needs of various applications.

The VRM front panel provides an LCD for system setup,

monitoring and troubleshooting. During normal opera-

tion, the LCD shows RF and audio levels, diversity

status, pilot tone status (where applicable) and transmit-

ter battery status (in certain modes) for all six receivers

at the same time. Individual screens for each receiver

provide additional information and adjustments.

A built-in analyzer scans the tunable spectrum of the

receiver to assist in ﬁnding clear operating frequencies.

The spectrum scan data is presented in a graphical

format on the LCD.

POWER Button

Turns the power on and off. A brief press also clears the

spectrum scan data after the spectrum analyzer has

been used. Press and hold the button for a few seconds

to turn the unit off.

Function Button

Used for various functions in selected Setup Screens as

labeled on the LCD.

BACK Button

The Back Button is used to return to the previous menu

or setup screen.

LCD Screen

The LCD is a backlit, graphics-type Liquid Crystal Dis-

play used to set up and monitor system operation.

Venue System Controls and Functions

Receiver Select Buttons

The six Receiver Select Buttons are used to select indi-

vidual installed receiver modules, for monitoring via the

PHONES jack and for setup and adjustment.

PUSH FOR MENU/SELECT Rotary Control

Thiscontrol,calledtheMENU/SELECTcontrolfor

short, is a pushbutton switch and rotary knob used for

navigating and selecting setup menus and screens, and

for selecting parameters within the setup screens.

PHONES Jack and LEVEL Control

The LEVEL control is used to adjust the output level

of the front panel PHONES jack for individual chan-

nel monitoring. It does not affect the output levels at

the rear panel XLR jacks. Only the audio from a single

receiver (or a diversity pair) selected via the Receiver

Select Buttons will be present at this jack.

The PHONES jack can also used as an audio output for

recording when using the Walk Test Recorder.

NOTE: An explanation of the Walk Test Recorder

is presented in the section entitled Setting Up the

Venue Receiver Using VRpanel.

Front Panel

1 2 3 4 5 6 7 8 9 10 11 ... 31 32

Comments to this Manuals

No comments

Lectrosonics Venue Series (Wideband) User Manual Page 6

Comments to this Manuals

Related products and manuals for Equipment Lectrosonics Venue Series (Wideband)