Lectrosonics SMV User Manual download pdf (Page 18)

SMV Series

LECTROSONICS, INC.

Straight Whip Antennas

Thisisafullsizecuttingtemplateusedtocutthelength

of the whip for a particular frequency. Lay the uncut

antenna on top of this drawing and trim the whip length

to the desired frequency.

After cutting the antenna to the desired length, mark the

antenna by installing a color cap or sleeve to indicate

the color listed in the table below

The supplied caps can be used several different ways:

1) A color cap on the end of the whip

2) A color sleeve next to the connector with a black

cap on the end of the whip (trim the closed end of

the colored cap off with scissors to make a sleeve).

3) A color sleeve and color cap (cut the cap in half

with scissors).

470

944

Note: Check the scale of your printout. This line should be 6.00 inches long (152.4 mm).

Whip Length

NOTE:

Not all Lectrosonics products are built on all of the blocks covered in

this table.

Factory supplied antennas precut to length include a label with the

frequency range. Label is not supplied with this kit.

470 470.100-495.600 Black w/ Label 5.67”

19 486.400-511.900 Black w/ Label 5.23”

20 512.000-537.500 Black w/ Label 4.98”

21 537.600-563.100 Brown w/ Label 4.74”

22 563.200-588.700 Red w/ Label 4.48”

23 588.800-614.300 Orange w/ Label 4.24”

24 614.400-639.900 Yelloww/Label 4.01”

25 640.000-665.500 Green w/ Label 3.81”

26 665.600-691.100 Blue w/ Label 3.62”

944 944.100-951.900 Black-w/Label 2.62”

BLOCK FREQUENCY CAP/SLEEVE ANTENNA

 RANGE COLOR WHIPLENGTH

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 27 28

No comments

Lectrosonics SMV User Manual Page 18