Lectrosonics UCR210d User Manual download pdf (Page 9)

UHF Wireless Diversity Receiver

INSTALLATION AND OPERATING INSTRUCTIONS

1. Install batteries or connect the power cord. Batteries should be inserted negative end first into the battery magazine. See the illustration

on the magazine.

2. Attach the antennas.

3. Set the frequency switches to match the transmitter frequency switch setting. See page 7.

4. Connect the audio cable to the audio output XLR.

5. Set the front panel Audio Output Level control to minimum and set the Power switch to ON (right position.) Check to see that the front

panel Power LED lights up.

6. Adjust the transmitter gain. THIS IS PERHAPS THE MOST IMPORTANT STEP IN THE SET UP PROCEDURE. See your

transmitter manual (Operating Instructions section) for details on how to adjust the transmitter gain. In general, adjust the transmitter

gain so that the voice peaks will cause the first Mod Level LED on the front of the receiver to light red on the loudest peak audio levels.

Normal levels should cause both LED’s to show green. This will result in the best possible signal to noise ratio for the system without

causing overload distortion.

7. Adjust the Audio Output control according to the type of input on your equipment. The Range switch sets the adjustment range of the

front panel Audio Output control and has three positions.

-20: The adjustment range is from –50dBm to –20dBm.

0: Allows an adjustment from –30dBm to 0dBm

+8: Sets the audio output to a fixed +8dBm with no front panel control.

The input levels of different cameras, VCRs, and PA equipment vary, which may require that you set the Audio Output control to an

intermediate position. Try different settings and listen to the results. If the output of the receiver is too high, you may hear distortion

or a loss of the natural dynamics of the audio signal. If the output is too low, you may hear steady noise (hiss) along with the audio.

The UCR210D audio output is designed to drive any audio input device from microphone level to +8dBm line level.

OUTPUT LEVEL ADJUST

2 (Hi)

1 (Common or Ground)

MID

511

MUTE

RELAY

MID

AUDIO

AMP

XLR

OUT

AND RANGE SWITCH

3 (Lo)

UCR210D Simplified Audio Output Circuit

Note:

When using the +8 dBm HI position of the output range switch, do not ground pin 2 or pin 3 of the XLR output! The output impedance is

only 50 Ohms (unbalanced) when in the HI position and this is not enough to isolate the audio amplifier from a short to ground. Distortion

will result

UCR210D REPLACEMENT PARTS and ACCESSORIES

Part No. Description

A8U UHF Marine Phosphor Bronze Antenna, straight connector - specify block

BP210AA Battery magazine - holds 4 AA batteries

32251 Velcro mounting strips

35753 Zippered, padded vinyl system pouch

PS200 Power supply cable locking plug on one end and a

Hirose plug on the other for hookup to a camera.

21586 Power supply cable with locking plug on one end and pigtail leads on the other

Rio Rancho, NM – USA

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Comments to this Manuals

No comments

Lectrosonics UCR210d User Manual Page 9

Comments to this Manuals

Related products and manuals for Equipment Lectrosonics UCR210d