Lectrosonics VRFIELD (Narrowband) User Manual download pdf (Page 12)

VR Field

OptiBlend (Ratio Diversity) Setup

1. From the Overview Screen, Navigate to SetupRx

and then to the DivMode Setup Screen.

2. Press the front panel Receiver Select Button for

either Receiver Module in the pair to be used for

OptiBlend diversity. (In the example, Receiver Se-

lect button 5 or 6 was pressed.)

3. Rotate the MENU/SELECT control to display “Ra-

tio.” The Receiver Module boxes on the screen bot-

tom will display “RAT” for both the selected receiver

an its compliment.

4. Repeat steps 2 and 3 for the remaining receiver

module pairs to be set to ratio diversity operation.

Frequency Diversity Setup

Frequency Diversity differs from the other two diver-

sity modes in that it uses two receiver modules and

two transmitters with each receiver module/transmitter

combination operating on a different frequency. In order

for Frequency Diversity to function properly, the audio

outputs of the two transmitters must be balanced. (See

Frequency Diversity Mode Audio Balancing to properly

balance the audio output from each transmitter.)

Note: Both transmitters must be the same model.

1. From the Overview Screen, Navigate to SetupRx

and then to the DivMode Setup Screen.

2. Press the front panel Receiver Select Button for

either Receiver Module in the pair to be used for

frequency diversity.

3. Rotate the MENU/SELECT control to display “Fre-

quency.” The Receiver Module boxes on the screen

bottom will display “FRQ” for both the selected

receiver an its compliment.

4. Repeat steps 2 and 3 for the remaining receiver

module pairs to be set to frequency diversity opera-

tion.

Compat (compatibility) Mode

This procedure assumes that the external equipment

has already been connected to the appropriate XLR

Audio Output Jacks on the rear panel.

For receiver modules set to switched diversity, each re-

ceiver module in the diversity pair is set independently

of the other member of the pair.

For receiver modules that are part of a ratio diversity or

frequency diversity pair, setting the compatibility mode,

audio levels, etc. for one member of the diversity pair,

sets the same parameter for the other member of the

diversity pair. The exception is for frequency diversity,

battery status monitoring can be set for each individual

transmitter.

Five compatibility modes are available for each receiver

module to match various transmitter types. They are:

Selection: Abbreviation:

Dig. Hybrid HYB

Mode 3 M3

200 Series 200

100 Series 100

IFB IFB

Mode 6 M6

The Compatibility Mode for each receiver module must

match the transmitter associated with that module.

1. To set a receiver’s compatibility mode,

navigate to the Compat Setup Screen.

2. Use the Receiver Select buttons to select

Receiver Module 1.

3. Rotate the MENU/SELECT control to

display the desired Compatibility Mode. An

abbreviation for the mode selected will be

displayed in the Receiver Module box for the

selected receiver(s).

4. Use the Receiver Select buttons to select the

next Receiver Module, or next receiver module

pair, and repeat Step 3.

Shortcut

It’s possible to shorten setup times by copying the

parameter of the currently selected receiver to other

receivers. This is done by pressing and holding the

Receiver Select button for current receiver module

and pressing the Receiver Select buttons for all

other receiver modules which are to receive the

same parameter.

Compatibility Mode

LECTROSONICS, INC.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 27 28

Comments to this Manuals

No comments

Lectrosonics VRFIELD (Narrowband) User Manual Page 12

Comments to this Manuals

Related products and manuals for Equipment Lectrosonics VRFIELD (Narrowband)